Using The Cutting-Unit Kickstand - Toro Reelmaster 5010-H Operator's Manual

Figure 30
Right rear cutting unit (#3)
1. Extra flange nut
2. Bulkhead bracket
5
Using the Cutting-Unit
Kickstand
Parts needed for this procedure:
1 Cutting-unit kickstand
Procedure
Whenever you need to tip the cutting unit to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand to make sure that the nuts on the
back end of the bedbar-adjusting screws are not
resting on the work surface
g316998
3. Connector plate
(Figure 31).
1. Cutting-unit kickstand
Secure the kickstand to the chain bracket with the
snapper pin (Figure
1. Chain bracket
2. Snapper pin
20
Figure 31
32).
Figure 32
3. Cutting-unit kickstand
g003985
g004144