Toro Reelmaster 5010-H Operator's Manual page 17

Figure 20
1. Cap
2. Snapper pin
3. Assemble the cap to the pivot yoke, and align
the holes in the carrier frame shaft, pivot yoke,
and cap.
4. Secure the pivot yoke and cap to the carrier
frame shaft with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting
Grass on a Hill Side—Lock the cutting-unit
pivots to prevent the cutting units from rotating
downhill when cutting across the face of a hill.
Use the hole in the pivot yoke
lock the cutting unit. Use the slot for a steering
cutting unit.
Figure 21
1. Snapper-pin positions
2. Hole (pivot yoke)
5. Slide a cutting unit under the lift arm
g375237
3. Pivot yoke
4. Carrier frame shaft
(Figure 21) to
g375251
3. Slot (pivot yoke)
(Figure 22).
1. Lynch pin
2. Lift-arm shaft
6. Insert the pivot yoke into the lift arm, and secure
shaft to the arm with the lynch pin and washer.
7. Repeat steps
cutting unit.
Installing the Cutting Unit Lift-Arm
Chains
Secure the lift-arm chain to the chain bracket with the
snapper pin (Figure
Note:
Use the number of chain links described in the
cutting unit Operator's Manual.
1. Lift-arm chain
2. Chain bracket
Assembling the Reel Motors to the
Cutting Units
1. Apply a coat of clean grease to the splines of the
reel-motor shaft.
2. Apply a coat of oil the reel motor O-ring and
install it onto the motor flange.
3. Align the motor to the cutting unit so that the
motor flanges clear the bolts clockwise
24).
17
Figure 22
3. Lift arm
4. Washer
1 through 6 for the other rear
23).
Figure 23
3. Snapper pin
g375239
g003948
(Figure