Seat Controls - Toro Reelmaster 5010-H Operator's Manual

Enable/Disable Switch
Use the enable/disable switch
conjunction with the lower mow/raise control lever to
operate the cutting units.
Headlight Switch
Pivot the switch downward to turn on the headlights
(Figure 42).
Power Point
The power point is a 12 V power supply for electronic
devices (Figure 43).
Figure 43
1. Power point
Cutting-Unit-Power Disconnect
Before installing, removing, or working on the cutting
units, disconnect the cutting units from the power
supply by separating the cutting-unit-power-disconnect
connector (Figure 44), located under the seat. Plug
the connector back in before operating the machine.
(Figure 42) in
g004133
1. Power-disconnect connector
CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally
start the cutting unit, causing serious injury
to hands and feet.
Always separate the
cutting-unit-power-disconnect connectors
before working on the cutting units.

Seat Controls

1. Weight gauge
2. Weight-adjusting knob
25
Figure 44
Figure 45
3. Height-adjusting knob
4. Adjusting lever
g027134
g003954