Setup; Preparing The Machine - Toro Reelmaster 5010-H Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
Media and Additional Parts
Description
Key
Operator's Manual
Engine owner's manual
Declaration of Conformity
Operator training material
Note:
Determine the left and right sides of the machine from the normal operating position.
1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface, lower the
cutting units, and engage the parking brake.
Description
No parts required
No parts required
Cutting units
Finishing kit (sold separately)
Cutting-unit kickstand
No parts required
Hood lock, seal, and jam nut
Washer
CE decal
Production year decal
Warning decal
Qty.
–
–
5
1
1
–
1
1
1
1
1
Qty.
2 Start the engine.
1 Read the Operator's Manual before operating the machine.
1 Use the manual to reference engine information.
1 Declaration of conformity
1
Review the material before operating the machine.
2. Shut off the engine, remove the key, and wait for
all moving parts to stop.
3. Check the tire air pressure before use; refer to
Checking the Tire Air Pressure (page
Note:
Adjust the tire air pressure before operating the
machine.
4. Check the hydraulic-fluid level; refer to
the Hydraulic-Fluid Level (page
5. Grease the machine; refer to
Bearings and Bushings (page
11
Use
Prepare the machine.
Adjust the control-arm position.
Install the cutting units.
Mount the finishing kits (finishing kits
are sold separately).
Install the cutting-unit kickstand.
Install the 48 V disconnect jumper and
closing the seat base.
Install the CE hood lock.
Apply the CE decals.
Use
The tires are overinflated for shipping.
61).
Checking
68).
Greasing the
47).