Toro Reelmaster 5010-H Operator's Manual page 24

Figure 41
1. Traction pedal
2. Mow/transport lever
3. Mow-speed limiter and
spacers
Mow/Transport Lever
Use the mow/transport lever
machine into M mode or T
OW
the lever forward to select the M
backward to select the T
Note:
The cutting units cannot be lowered when the
mow/transport lever is in the T
Mow-Speed Limiter
When the mow-speed limiter
up/forward it limits the mow speed and allow the
cutting units to be engaged. Each spacer adjusts
the mowing speed by 0.8 km/h (0.5 mph). The more
spacers there are on the top of the bolt, the slower the
machine goes. Flip the mow speed limiter backward
to allow maximum transport speed.
Brake Pedal
Press the brake pedal (Figure
Parking Brake
To engage the parking brake,
on the brake pedal and press the top forward to latch
it. To release the parking brake, press the brake pedal
until the parking-brake latch retracts.
4. Brake pedal
5. Parking brake
6. Tilt steering pedal
(Figure 41) to put the
mode. Push
RANSPORT
mode, and
OW
mode.
RANSPORT
position.
RANSPORT
(Figure 41) is flipped
41) to stop the machine.
(Figure 41) push down
Tilt-Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal (Figure 41) down, pull the steering tower toward
you to the most comfortable position, and release the
pedal.
Engine-Speed Switch
The engine-speed switch has 2 modes to change the
engine speed (Figure
switch, you can change the engine speed in 100 rpm
increments. If you hold the switch down, the engine
automatically moves to High or Low idle, depending
on which end of the switch you press.
g003955
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Lower Mow/Raise Control Lever
This lever (Figure
units and also starts and stops the cutting units when
the cutting units are enabled in the M
cannot lower the cutting units when the mow/transport
lever is in the T
Key Switch
The key switch
O /P , and S
N REHEAT
InfoCenter
The InfoCenter LCD display shows information about
your machine, such as the operating status, various
diagnostics, and other information about the machine
(Figure 42).
24
42). By momentarily tapping the
Figure 42
4. Enable/disable switch
5. Engine-speed switch
6. Headlight switch
42) raises and lowers the cutting
OW
position.
RANSPORT
(Figure 42) has 3 positions: O
.
TART
g021208
mode. You
,
FF