Toro Reelmaster 5010-H Operator's Manual page 16

Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Higher Height of Cut
1. Slide a cutting unit under the lift arm
Figure 17
1. Cap
2. Snapper pin
2. Assemble the pivot yoke onto the carrier frame
shaft.
3. Assemble the cap to the pivot yoke and align
the holes in the carrier frame shaft, pivot yoke,
and cap.
4. Secure the pivot arm shaft and cap to the carrier
frame shaft with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting
Grass on a Hill Side—Lock the cutting-unit
pivots to prevent the cutting units from rotating
downhill when cutting across the face of a hill.
Use the hole in the pivot yoke
lock the cutting unit. Use the slot for a steering
cutting unit.
(Figure 17).
g375252
3. Pivot yoke
4. Carrier frame shaft
(Figure 17) to
1. Snapper-pin positions
2. Hole (pivot yoke)
5. Repeat steps
unit.
Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Lower Height of Cut
1. Remove the lynch pin and washer securing the
to the pivot yoke to the lift arm, and slide the
shaft out of the lift arm
1. Lynch pin
2. Pivot yoke
2. Assemble the pivot yoke onto the carrier frame
shaft (Figure 20).
16
Figure 18
3. Slot (pivot yoke)
1 and 2 for the other rear cutting
(Figure 19).
Figure 19
3. Lift arm (rear cutting unit)
4. Washer
g375251
g375236