6
Installing the 48 V
Disconnect Jumper and
Closing the Seat Base
No Parts Required
Procedure
1.
Apply dielectric grease to the contact surfaces
of the battery disconnect jumper
Figure 33
1. 48 V system connector
2.
Plug the battery disconnect jumper into the 48 V
system connector.
3.
Rotate the seat and seat base closed, and latch
the base
(Figure
Figure 34
1. Latch (seat base)
(Figure
2. Battery disconnect jumper
34).
7
Installing the CE Hood Lock
Parts needed for this procedure:
1
Hood lock, seal, and jam nut
1
Washer
Procedure
1.
Unlatch and raise the hood.
33).
2.
Remove the rubber grommet from the hole in
the left side of the hood
g353655
1. Rubber grommet
3.
Ensure that the seal is assembled to the hood
lock
(Figure
g379173
21
(Figure
35).
Figure 35
36).
g027072