Huawei FusionModule500 User Manual page 92

FusionModule500 Smart Mini Data Center
User Manual
Procedure
Step 1 Place the low-temperature component in an open indoor area.
Figure 4-20 Appearance of a low-temperature component
Figure 4-21 Interior of a low-temperature component
Step 2 Connect pipes. The low-temperature component has no dedicated wiring terminal
and uses the 5 m power cable delivered with it.
The low-temperature component pipes need to be welded. The procedure is as
follows:
1.
2.
3.
4.
Issue 02 (2020-12-25)
Remove the side panel with knock-out holes.
Knock off the sheet metal from the knock-out holes on the side panel and fit
the side panel into the copper pipes to be welded.
Weld the liquid inlet pipe and liquid outlet pipe.
Secure the side panel to the low-temperature component.
Copyright © Huawei Technologies Co., Ltd.
4 Installation Guide
82