Huawei FusionModule500 User Manual page 121

FusionModule500 Smart Mini Data Center
User Manual
Procedure
Step 1 Figure 4-53
cable.
Figure 4-53 Connecting cables
(1) Conversion cable end B, connected to the
water detection cable
Step 2 Connect the other end of the conversion cable to the water detector, as shown in
Figure
Figure 4-54 Connecting the water detector
Step 3 Plan the installation position for the fastener of the water detection cable. Ensure
that the water detection cable placed on the fastener is in good contact with the
floor.
Step 4 Tear off the protection paper from the rear of the fastener, and then securely
attach the fastener to the floor.
●
●
Step 5 Drill holes in the floor with the same dimensions as the expansion bolts for the
fastener. Use the expansion bolts to secure the fastener to the floor, as shown in
Figure
Issue 02 (2020-12-25)
shows how to connect the water detection cable to the conversion
NO TE
The water detection cable and conversion cable are interconnected through the male and
female connectors.
4-54.
If the fastener cannot be securely attached to the floor, go to
If the fastener is securely attached to the floor, go to
4-55.
Copyright © Huawei Technologies Co., Ltd.
(2) Water detection cable end A, connected to
the conversion cable
Step
4 Installation Guide
Step 5.
6.
111