Huawei FusionModule500 User Manual page 183

FusionModule500 Smart Mini Data Center
User Manual
Table 5-7 Setting device addresses
Address
1
2
Step 2 Add a T/H sensor.
1.
2.
3.
Step 3 Check the function of the T/H sensor.
Table 5-9 Function check
Check Method
Check the running
information about the T/H
sensor on the WebUI.
Issue 02 (2020-12-25)
Toggle
Switch 1
ON
OFF
Log in to the ECC800-Pro WebUI as an administrator.
Add a T/H sensor.
Table 5-8 Adding a T/H sensor
Path Parameter
Choose Device
System Attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device.
Communica
tions Port
Device
Address
Click Test Connect to check whether the T/H sensor connects to the ECC800-
Pro properly.
– If the connection is normal, click Confirm. The connected devices are
displayed in the Number of connected devices list.
– If the connection is abnormal, check whether the device is properly
connected to the ECC800-Pro, whether the device and the ECC800-Pro are
running properly, and whether the parameter settings are consistent with
the device parameters.
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle
Switch 2 Switch 3
OFF OFF
ON OFF
Setting
Select Sensor from the drop-down list box.
Select T/H sensor from the drop-down list
box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
In this example, Device Address is set to 1.
During actual configuration, set the device
address for the T/H sensor based on the
actual situation.
Normal Connection Status
Choose Monitoring > Aisle > T/H Sensor Group
> T/H Sensor n > Running Info, and view the
current cabinet temperature and humidity.
5 Power-On Commissioning
Toggle Toggle
Switch 4 Switch 5
OFF OFF
OFF OFF
Toggle
Switch 6
OFF
OFF
173