Huawei New Main Way 2.0 User Manual page 36

New Main Way 2.0
User Manual
Step 7 Level the supports and secure them.
1.
2.
Figure 3-26 Leveling and securing supports
Step 8 Install the connective kit.
● After inserting the connective kit into the busbar trunking unit, ensure that the
● You need to partially tighten the two bolts in the upper area of the connective
● In this example, the torque for tightening M12 bolts on the connective kit is 45
Issue 05 (2020-10-15)
Adjust the screw on the top of the support clockwise to raise the support. If
you adjust it counterclockwise, the support is lowered.
Use a level to check that the supports are on the same horizontal line.
NO TICE
connective kit fully comes in contact with the copper bar.
kit, and tighten the bolts after installing the protective covers.
N·m. For the actual torque, see the label on the connective kit.
Copyright © Huawei Technologies Co., Ltd.
3 Installation
30