Secure The Cables; Check Walking Belt Tension And Tracking; Check Emergency Stop Switch; Self-Calibration - GE T2100 Service Manual

Secure the Cables

Tie down cables to ensure they do not get caught in the wheels or the elevation racks.

Check Walking Belt Tension and Tracking

Operate the walking belt at various speeds and verify that it tracks evenly down the
center of the walking board. If not, adjust the walking belt tracking. See
Tracking And Tension Adjustment" on page

Check Emergency Stop Switch

1. Manually control the speed of the T2100 Treadmill from the controlling device.
With the belt moving at a relatively high speed, press the emergency stop
switch. The T2100 Treadmill belt will stop promptly but the belt will not lock,
allowing for removal of foreign objects. To release the switch, turn the button
1/4 turn.
2. Use the controlling equipment to terminate the exercise session and turn off the
T2100 Treadmill.

Self-Calibration

The T2100 Treadmill has a built-in self-calibration routine.
WARNING:
INJURY TO PERSON. Keep hands, hair, jewelry, and loose clothing away from
moving parts.
Do not place feet under T2100 Treadmill during elevation changes. Otherwise,
serious injury could result.
WARNING:
INJURY TO PERSON. During the self-calibration process the T2100 Treadmill will
elevate to its maximum grade. Make sure you monitor the site at all times.
Make sure there are no customers or patients on or near the T2100 Treadmill
during self-calibration.
To activate the self-calibration routine, do the following:
1. Remove controlling device (CASE) cable or turn off the controlling device.
2. Unlock the emergency stop switch.
3. Connect the AC power cord on the T2100 Treadmill to the wall outlet.
2021403-120F
54.
T2100 Treadmill
Installation
"Walking Belt
45