Drive Controller Assembly
Drive Controller Replacement Procedure
1.
Turn the ON/OFF switch to the OFF position, disconnect the power cord from the
wall outlet, and remove the shroud.
2.
Remove the 2 resistor mounting nuts.
3.
Disconnect all connectors from the drive controller.
4.
Remove the 4 nuts from the drive controller mounting bracket and remove the
mounting bracket and drive controller from the T2100 Treadmill.
5.
Remove the 4 nuts from the drive controller fastening points.
6.
Remove the drive controller and replace with a new drive controller in reverse
order.
7.
Calibrate the T2100 Treadmill. See
Drive Controller X1 PIN Descriptions
Follow this diagram when wiring the X1 connection. Tighten each terminal to a torque
of 0.5–0.6Nm (4.4–5.3 lb-in).
2021403-120F
Item
Description
1
Connectors (plugs)
2
Resistor Mounting Nuts
3
Drive Controller Mounting Bracket
There are two (2) mounting nuts on top and two (2) under the drive
controller.
4
Drive controller fastener points four (4)
T2100 Treadmill
"Self-Calibration" on page
FRU Replacement
45.
121