Rear Roller Replacement - GE T2100 Service Manual

FRU Replacement
9. Install the new roller in reverse order, and then adjust the drive belt tension
and tracking. See
Tracking" on page
10. Adjust walking belt tracking and tension. See
on page
11. Calibrate the T2100 Treadmill. See

Rear Roller Replacement

1. Turn the ON/OFF switch to the OFF position and disconnect the power cord
from the wall outlet.
2. Remove the walking belt tension screws on the end of the T2100 Treadmill and
remove the end caps.
Arrows point to location of tension screws.
3. Locate the roller bolt access holes and remove the 9/16 inch bolt from one side.
4. While supporting the free end of the roller, remove the 9/16 inch bolt on the
opposite side of the T2100 Treadmill.
5. Lift the roller up and slide it out of the belt.
6. Install the new roller in reverse order, and then adjust the walking belt tracking
and tension. See
7. Calibrate the T2100 Treadmill. See
110
"Drive Belt Adjustments" on page 117
118.
55.
"Walking Belt Tension Adjustment" on page
T2100 Treadmill
and
"Walking Belt Tension Adjustment"
"Self-Calibration" on page
"Self-Calibration" on page
"Adjust Drive Belt
45.
55.
45.
2021403-120F