Elevation Motor Replacement - GE T2100 Service Manual

sprocket until the drive belt tracks in the center of the lower sprocket. When the
drive belt is tracking correctly, calibrate the T2100 Treadmill. See
page 45.

Elevation Motor Replacement

1. Use the controlling equipment to elevate the T2100 Treadmill approximately
6 inches (15 cm), and until the set screws on the elevation shaft collar are
accessible.
Arrows point to the location of the two elevation shaft collar set screws.
NOTE:
2. Turn the ON/OFF switch to the OFF position, disconnect the power cord from the
wall outlet, and remove the shroud.
3. Remove the elevation shaft collar set screws.
4. Remove the elevation potentiometer (under the electronics box). See
"Potentiometer Removal Guidelines" on page
5. Disconnect the elevation motor power cable plug and jumpers at the electronics
box and remove all tie wraps on the cable.
6. Place the T2100 Treadmill on its side so the elevation motor is on top.
7. Remove the two visible mounting bolts on the elevation motor.
2021403-120F
It is important to raise the T2100 Treadmill to give access to an elevation
motor mounting bolt later in this procedure.
T2100 Treadmill
FRU Replacement
"Self-Calibration" on
126.
119