Secure The Cables; Check Walking Belt Tension And Tracking; Check Emergency Stop Switch; Self-Calibration - GE T2100 Service Manual

Secure the Cables

Check Walking Belt Tension and Tracking

Check Emergency Stop Switch

Self-Calibration

3-10
Installation: Equipment Assembly
4. Turn the GE T2100 Treadmill power switch On.
5. Turn the controlling device power switch On.
Tie down cables to ensure they do not get caught in the wheels or the
elevation racks.
Operate the walking belt at various speeds and verify that it tracks
evenly down the center of the walking board. If not, adjust the walking
belt tracking. See "Walking Belt Tracking and Tension Adjustment"
page 4-5.
1. Manually control the speed of the GE T2100 Treadmill from the
controlling device. With the belt moving at a relatively high speed,
press the emergency stop switch. The GE T2100 Treadmill belt will
stop promptly but the belt will not lock, allowing for removal of
foreign objects. To release the switch, turn the button 1/4-inch turn
in either direction.
2. Use the controlling equipment to terminate the exercise session and
turn off the GE T2100 Treadmill.
The GE T2100 Treadmill has a built-in self-calibration routine.
WARNING
INJURY TO PERSON
Keep hands, hair, jewelry, and loose clothing away from
moving parts. Do not place feet under GE T2100
Treadmill during elevation changes. Otherwise, serious
injury could result.
WARNING
INJURY TO PERSON - During the self-calibration
process the GE T2100 Treadmill will elevate to its
maximum grade. Make sure you monitor the site at all
times.
Make sure there are no customers or patients on or near
the GE T2100 Treadmill during self-calibration.
GE T2100 Treadmill
2021403-031
on
Revision A