Table of Contents
Advertisement
Figure 55
1. Front frame channel
2. Right side of the machine
3.
Remove the 8 flange bolts (3/8 x 1 inch), 8
flange locknuts (3/8 inch), bottom bracket, and
ball-picker mount from the machine
4.
Centerpunch the 6 marks that you made on the
center-channel plate in step 2.
5.
Drill 6 holes 10 mm (3/8 inch) in the
center-channel plate at the centerpunch marks
that you made in step 4.
Figure 56
1. Front frame channel
g237675
3. Hole (Ball-picker mount)
(Figure
52).
g237751
2. Drill bit 10 mm (3/8 inch)
Assembling the Ball-Picker Mount
to the Machine
1.
Assemble the ball-picker mount and the
bottom bracket to the front frame channel and
center-channel plate
Figure
59) with 14 flange bolts (3/8 x 1 inch) and
14 flange locknuts (3/8 inch).
1. Flange bolt (3/8 x 1 inch)
2. Ball-picker mount
1. Flange bolt (3/8 x 1 inch)
2. Ball-picker mount
25
(Figure
57,
Figure
Figure 57
3. Flange locknut (3/8 inch)
4. Bottom bracket
Figure 58
3. Bottom bracket
4. Flange locknut (3/8 inch)
58, and
g237727
g237880
Advertisement
Table of Contents
