6.
Centerpunch the 4 marks that you made on the
center-channel plate in step 4.
7.
Drill 4 holes 10 mm (3/8 inch) in the
center-channel plate at the centerpunch marks
that you made in step
1. Center-channel plate
Drilling the Front Frame Channel
1.
Loosely assemble the bottom bracket, ball-picker
mount and center-channel plate as shown in
Figure 52
with 8 flange bolts (3/8 x 1 inch) and 8
flange locknuts (3/8 inch).
1. Flange bolt (3/8 x 1 inch)
2. Ball-picker mount
2.
Mark the 6 hole locations of the bottom bracket
onto the center-channel plate as shown in
figures
Figure
53,
6 (Figure
51).
Figure 51
2. Drill bit 10 mm (3/8 inch)
Figure 52
3. Flange locknut (3/8 inch)
4. Bottom bracket
Figure
54, and
Figure
1. Hole (Ball-picker mount)
g237672
1. Ball-picker mount
2. Left side of the machine
g237727
55.
24
Figure 53
2. Front frame channel
Figure 54
3. Front frame channel
g237674
g237676