Table of Contents
Advertisement
6
Installing the ROPS
Extension
Parts needed for this procedure:
1
Left windshield support
1
Right windshield support
1
Front support
1
Rear canopy support
1
Left, front mount bracket
1
Right, front mount bracket
1
Left, rear mount bracket
1
Right, rear mount bracket
1
Left, rear corner gusset
1
Right, rear corner gusset
1
Left, front corner gusset
1
Right, front corner gusset
1
Front crosslink
2
Crosslink tube
30
Flange nut (5/16 inch)
2
Nut (1/4 inch)
2
Hex-head flange bolt (1/4 x 1-1/2 inches)
16
Carriage bolt (5/16 x 1-3/4 inches)
2
Hex-flange bolt (5/16 x 1 inch)
6
Carriage bolt (5/16 x 2-3/4 inches)
4
Carriage bolt (5/16 x 1 inch)
Procedure
Note:
Do not tighten any fasteners except when
instructed.
1.
Using the dimensions shown in
2 holes (5/16 inch) into the outside of the floor
plate on the left and right sides of the machine.
2.
Using the dimensions shown in
hole (5/16 inch) into the outside of the footboard
on the left and right sides of the machine.
3.
Secure the middle bracket of the left and right
windshield supports to the machine using 2
hex-flange bolts (5/16 x 1 inch) and 2 nuts (5/16
inch) in the holes you drilled
15
Figure
Figure 29
Figure
30, drill 1
Figure 30
(Figure
31).
29, drill
g036552
g036553
Advertisement
Table of Contents
