Table of Contents
Advertisement
Removing the Bumper from the
Machine
1.
While supporting the bumper, remove the 8
flange-head bolts that secure the bumper to the
bumper mounts and headlight brackets
42)
Figure 42
1. Bumper
2. Bumper and headlight
mount
2.
Remove the bumper from the machine.
(Figure
g237475
3. Flange-head bolt
10
Installing the Headlight
Guards
Parts needed for this procedure:
2
Headlight guard
4
Flange bolt (5/16 x 5/8 inch)
Installing the Headlight Guards
1.
Remove the 2-socket connector of the machine
wire harness from the 2–pin connector at the
back of the head light
Note:
Retain the clips for assembly.
1. Headlight-adjusting nut
2. Headlight bracket
2.
Remove the 3 clips from the 3 headlight-adjusting
nuts, and remove the headlight from the
headlight bracket
3.
Inspect the headlight mount brackets for the
headlight guard mounting holes.
If the headlight mount brackets do not have
mounting holes, use the measurements in
Figure 44
to drill 2 holes—11 mm (7/16 inch) in
each of the headlight mount brackets.
21
(Figure
43).
Figure 43
3. Clip
4. 2-socket connector
(machine wire harness)
(Figure
43).
g237538
Advertisement
Table of Contents
