Load Unit - GE eBike III basic Series Service Manual

l
oad unIt
a
sseMBly
The eBike III ergometers are equipped with an identical
load unit (brake unit) with an eddy current brake of
1000 Watt.
l
oad unIt replaCeMent
1. Grab the eBike at handlebar and saddle and carefully
lay it sideways on one side.
2. Disconnect all cables from the electronic boards.
3. The load unit is secured with six Allen key screws on
the ergometer chassis.
Brace the load unit from falling over and then using a
socket wrench, loosen the screws.
Use a torque wrench to tighten the screws of the new load
unit with a torque of 25 Nm.
2018111-336 Rev. B
a
SSembly of the load unit
1 Galvanized steel housing
2 Precision bearings
3 Calibrated strain gauge module
4 Eddy current brake (1000 W)
5 Special drive belt
eBike III basic / comfort - 55 -