GE eBike III basic Series Service Manual page 13

f C p
unCtIonal HeCkout roCedure
Visual / functional checks
1. External surfaces passed inspection?
2. Plastic cover screws complete and fixed?
3. Plastic caps on housing screws complete?
4. Terminal foil, LCD and LED passed inspection?
5. AC Power cord passed inspection?
6. AC power cord strain relief mounted and cable secured
7. Casters passed inspection?
8. All board connectors and cable connectors connected and secured?
9. All PCBs fixed with screws on electronic carrier?
10. All harnesses' and internal wiring has been secured?
11. Bellow on saddle passed inspection?
12. Saddle fixture on saddle tube passed inspection?
13. Handlebar adjustment (angle) passed inspection?
(refer to „Handlebar - Adjust fixture (inclination)" on page 37)
14. Clamping lever handlebar angle adjustment passed inspection?
15. eBike III basic only: Mechanical saddle height adjustment passed inspection?
16. eBike III basic only:Clamping lever saddle height passed inspection
(tight; thread of lever is greased)?
17. eBike III comfort only: Saddle motor keys at terminal functional?
18. eBike III comfort only: Electrical saddle adjustment passed inspection?
19. eBike III comfort only: Check correct indication of saddle height display
20. eBike III comfort only: Check if saddle tube moves tightly and without any mechanical wobble
in saddle tube guidance.
21. Check software (firmware) is at correct version GF 1.x
(refer to „Software update" on page 78)
22. Check and clear the "error log file" in service menu
(refer to „Error log" on page 67)
23. Check stable position on floor, check leveler adjustment
Operational Checks
24. Power-up self-test passed (no error messages on LCD)?
25. LCD contrast ok?
(refer to „Contrast" on page 62)
26. eBike successfully communicates with ECG device?
(refer to „Connectivity and installation eBike III to GE ECG devices" on page 81)
27. Check load level and load indication on LCD
28. Set manual load (see „Manual Load" on page 66),
change load (for example, 50 W, 100 W)
Check noise level of idling drive unit (for example, for grinding noises or noise from the bearing)
29. Check speed indication (rpm) displayed on LCD and the additional speed indication
on the patient display.
30. Blood pressure measurement successfully initiated by ECG device?
31. Blood pressure values successfully communicated to ECG device
32. Check cuff tubing and tubing connections, microphone connectors
33. Check blood pressure measurement on test subject at rest
34. Check blood pressure readings on LCD
Tests and Calibration Checks
35. System configuration and settings correct?
(refer to „System Config." on page 66)
36. NIBP test successfully passed?
(refer to „NIBP Test" on page 76)
37. NIBP calibration successfully performed?
(refer to „NIBP Calibration" on page 77)
2018111-336 Rev. B
d
etaIls
eBike III basic / comfort
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
pass/fail
- 13 -