Figure 3.13 Installing Optional Modem Daughtercards On The Mp40; Interface Boards - Samsung OfficeServ 7400 Technical Manual

OfficeServ 7400
TECHNICAL MANUAL
Mount the MODEM as shown below:

Figure 3.13 Installing Optional Modem Daughtercards on the MP40

3.3 INTERFACE BOARDS

This section describes how to set jumpers and switches of an interface board, how to install
optional daughterboards to an interface board, and how to install interface boards into slots.
3.3.1 Installing Interface Boards
Interface boards can be installed in any universal slot according to the rules outlined in Table
3.1. Universal slots are slots 1, 2, and 4~11 in the main cabinet and slots 1~11 in the
OfficeServ 7400 expansion cabinets. For OS7200 expansion cabinets, universal slots are slots
1~5.
The procedure for installing the interface board to each slot is as follows:
1) Check the exterior of the interface board for any damage.
TURN OFF ALL POWER TO THE SYSTEM BEFORE INSTALLING A CARD.
Align each interface board to the guardrails of the universal slot and slide the interface board
into the slot.
MODEM
3.15
Home Page Home Page Table of Contents Table of Contents
INSTALLATION
PART 3 MAY 2010