Samsung OfficeServ 7400 Technical Manual page 150

OfficeServ 7400
TECHNICAL MANUAL
2. Modem Options
The Modem Options tab allows you to set configuration parameters for MODEM
connections. Once changes have been made you must click [Apply] to save them.
 Dial Retry sets the number of outcall attempts to make. The default is 1, which
means that if the call fails or isn't answered there will be no more attempts
made.
 Dial Duration sets the length of time to wait for a connection to be made. The
default setting is 90 seconds, which means that if a connection isn't established
within 90 seconds of seizing the trunk the call will be considered a failed
attempt.
 Dial Type sets whether the MODEM should dial using DTMF or Pulse dialing.
 Initial Command sets the initialization string to use to setup the MODEM call.
The default is AT&F, which is compatible with 99% of MODEMs manufactured
since 1990. It is recommended that you leave this setting as is unless instructed
to change it by the MODEM manufacturer.
Figure 7.45 MODEM Options
7.46
Home Page Home Page Table of Contents Table of Contents
INSTALLATION
PART 7 JANUARY 2011