Figure 4.1 Connecting An External - Samsung OfficeServ 7400 Technical Manual

OfficeServ 7400
TECHNICAL MANUAL
Observe the following precautions when installing batteries:

Make sure the batteries you install conform to local building, fire and safety codes. Some
battery types emit hydrogen gas during the charging state and may require venting to
fresh air.

Do not place batteries directly on a concrete floor. This causes them to discharge very
quickly.

Follow the battery manufacturer's recommended installation and maintenance
procedures.
PROCEDURE FOR CONNECTING EXTERNAL BATTERY
The procedure for using a battery cable to connect an external battery to the OfficeServ 7400
system is as follows:
1) Prepare the battery cable that was provided with the OfficeServ 7400 system. The battery
cable consists of a red line and a blue line, and at the end of each line, GND (red line), -
48VDC (blue line) are labeled. The other part of battery cable has a connector for the
battery socket of OfficeServ 7400 system.
2) Connect the red line (GND) of the battery cable to the (+) terminal, and the blue line (-
48 VDC) to the (-) terminal of the battery. Then, connect the other end of the battery cable
to the external battery socket on the rear panel of the OfficeServ 7400 cabinet.
Figure 4.1 Connecting an External Battery (1)
4.2
Home Page Home Page Table of Contents Table of Contents
INSTALLATION
PART 4 MAY 2010
(+)
(-)