Samsung OfficeServ 7400 Technical Manual page 108

OfficeServ 7400
TECHNICAL MANUAL
CONNECTING TO 8COMBO/8COMBO2
Connect a digital phone to the 8COMBO/8COMBO2 board by using a twisted pair of AWG #24 or
AWG #26 wires.
D1-D8 Port
Pin No.
Function
7.1.4 Connecting an IP Phone
Refer to the ITP-5121D Keyset User Guide, ITP-5112L Keyset User Guide, ITP-5107S Keyset User
Guide, SMT-i3105 User Guide, SMT-i5210 User Guide, SMT-i5220 User Guide, SMT-i5230 User
Guide, and SMT-i5243 User Guide for information on connecting IP keysets.
CAUTION: The input power of the SMT-i Series phones needs 5.0vDC and 3000mA. The SMT-i5210, SMT-
i5220, SMT-i5230, and SMT-i5243 need to be powered by using Samsung's SMT-A53PW power adapter.
The SMT-i3105 requires the SMT-A53PA power adapter. Failure to use the appropriate power supply will
cause permanent damage to the phone and will void Samsung's warranty.
7.1.5 Connecting SIP Stations
There is no physical SIP station card required to use the SIP station service. In order to use a
generic (non-Samsung) SIP device (phone, softphone, terminal adapter), the OfficeServ
system must be IP-enabled. This means the OfficeServ system must have a SIP Stack License
key, MGI channels virtual ports, MGI channels, with the latest software MP software, and have
a high speed internet connection. Please refer to the "OfficeServ Series SIP Station Quick
Reference Document" for more information about configuring the OfficeServ SIP Server.
7.1.6 Connecting Cards to LAN
GWIM/GWIMT/PLIM/PLIM2/GPLIM/GSIM/MGI/MGI-16/MGI-64/MP40/LP40/SVMi20E/TEPRI2/
OAS boards can be connected to Ethernet by using an Ethernet cable.
Pin No.
Modules with standard
10/100 Base-T LAN
connector
Function
1 2 3
- - - DLI TIP
Figure 7.6 RJ-45 Port of the 8COMBO/8COMBO2 (For Digital Phone)
1 2 3
Tx+ Tx- Rx+
Tx+ Tx- Rx+
Figure 7.7 LAN Connections
7.4
Home Page Home Page
D1~D8
Port
(RJ-45)
4 5 6
DLI RING -
RJ-45 Port
4 5 6
- - Rx-
RTN RTN Rx-
Table of Contents Table of Contents
INSTALLATION
PART 7 JULY 2010
7 8
- -
7 8
- -
-48V -48V