Table 3.6 Ports And Leds Of The Tepri - Samsung OfficeServ 7400 Technical Manual

OfficeServ 7400
TECHNICAL MANUAL
Front panel components of the TEPRI:
Ports & LEDs Function Description
T1/E1/PRI Ports that connect the T1/E1/PRI cable.
SIO Serial port (for Samsung Use ONLY)
RST Button for resetting the TEPRI/TEPRIa board.
SYNC LED Clock synchronization.
- On: Indicates loss of framing (Error Condition).
- Off: Clocks are synchronized when they inter-work with the counterpart station
LOS LED This LED indicates loss of signal.
- On: Signals have been lost, no PCM clocking is being received.
- Off: Signals being received (Normal).
AIS LED This LED indicates whether the T1/E1 remote alarm has been generated.
- On: The remote alarm has been generated. All one's are being received (Error)
- Off: The remote alarm has not been generated (Normal).
L2 LED This LED indicates the operation status of Layer 2.
- On: The PRI Layer 2 is operating properly. PRI message is being received.
- Off: The PRI Layer 2 is operating abnormally.
IPC LED This LED indicates that this board is inter-working with the higher-level
module.
- On: The board is inter-working with the MCP/LCP.
- Off: The board is not inter-working with the MCP/LCP.
CLK LED This LED indicates whether this board is a master or slave.
- On: The board has received the synchronization clock from the counterpart
station.
- Off: Using synchronous clock for internal clock.
TP1 LED This LED indicates whether the T1 is established.
- This LED turns on once the T1 is established.
TP2 LED This LED indicates whether the PRI is connected.
- This LED turns on once the PRI is connected.

Table 3.6 Ports and LEDs of the TEPRI

(Normal).
3.21
Home Page Home Page Table of Contents Table of Contents
INSTALLATION
PART 3 MAY 2010