While Login The Database Backup Tool,It Appears Fail To Connect The Server - Huawei MA5600 Manual

NGN Cases
server is restarted. You can infer that the N2000 BMS is not connected after it is restarted.
3. The broadband devices are not affected by the restart. Therefore, you can start with the
difference in the management mode of narrowband devices. Through consultation, you know
that the server is configured in the same network segment as the broadband devices, and that the
narrowband devices in another network segment are managed through static routes.
4. The static routes may be lost during the restart of the N2000 BMS. Configure the static routes
again. The N2000 BMS resumes its management of the narrowband NEs.
Suggestions and
The N2000 BMS server can manage both the broadband service and the narrowband service in
Summary:
different network segments. In this case, the default network card on the server is configured
with an IP address that is in the same network segment as the broadband service. To enable the
server to manage the narrowband service, you should configure static routes from the
narrowband NEs to the server. To prevent loss of routes during the restart of the system, add the
static routes to the start items on the server as follows:
1. Write the following route starting script in the rc3 file in the path /etc on the SUN
workstation: route add network address –netmask subnet mask gateway address.
Example: #route add 192.168.10.0 -netmask 255.255.255.0 10.11.201.254
2. On Windows, write the configured routes mentioned above in a batch processing file (*.bat)
and add them to the start items of the system.

6.15 While login the Database Backup Tool,it appears Fail to connect the server

Title: While login the Database Backup Tool,it appears Fail to connect the server
ID: SE0000396249
Update Time: 2009-06-30 16:07:32
Author: Yanzhikuan 00145384
Product Family: Access Network Management System
Fault Type: Network Management Platform
Keywords: BMS DatabaseBackupTool
Phenomenon De
While login the Database Backup Tool,it appears "Fail to connect the server"
scription:
Version Information:
Network Managemant systemVersion:V200R011C02B026SPC003
Database system:SYBASE
OS:Windows
Alarm Informat
"Fail to connect the server"
ion:
Cause Analysi
1. check the N2000 client and Sysmonitor whether can login normal;
s:
2. check the Database Backup Process of Sysmonitor whether is normal;
3.check the file of n2000/server/conf/dbback/LogInfo.cfg whether is more than 32k;
4. LOG is more than 32k,it is too large.
Handling Proce
1. Stop the Database Backup Process in sysmonitor.
ss:
2. Move out the original LogInfo.cfg,then Create a new blank LogInfo.cfg
# cd /opt/n2000/server/conf/dbback/
# mv LogInfo.cfg LogInfo.cfg.bk
# touch LogInfo.cfg
# chmod 777 LogInfo.cfg
3. Modify the file n2000/server/conf/dbback/CRCRecord.cfg,make the value of log num to 0?
# vi CRCRecord.cfg
[CRC_NOMBER]
CRCNumber=0
4. start the Database Backup Process in sysmonitor
Suggestions and
NO
94
Confidential Information of Huawei. No Spreading without Permission
Chapter 6 iManager N2000 BMS Cases
Product: iManager N2000 BMS