Operating The N2000 Bms Through The Monitor Fails Because Of A Fault Of The Input And Output Modes - Huawei MA5600 Manual

NGN Cases
6.12 Failure in the Establishment of the Replication Relation on the HA System (Watchman)
Because of Inconsistency of the Name of the Replication Link
Title:
Failure in the Establishment of the Replication Relation on the HA System (Watchman)
Because of Inconsistency of the Name of the Replication Link
ID: SE0000365189
Update Time: 2008-12-23 10:42:00
Author: z46041
Product Family: Access Network Management System
Fault Type: Network Management Platform
Keywords: Watchman, rlink, replication relation
Phenomenon De
After the Force Active or Force Standby operation is performed, the replication relation of the
scription:
HA system (Watchman) fails to be established.
Alarm Informat
Replication status is abnormal!
ion:
Cause Analysi
The replication link is tried to be set up through VEA on site which causes that the name of the
s:
replication link in VEA is set to rlk_serverIP_wm_rvg. Therefore, the name of the replication
link is inconsistent with that of the rlink on the HA system (Watchman).
Handling Proce
1. Query the alarms and logs and find that the rlk_10.0.0.20_wm_rvg file exists. The
ss:
rlk_10.0.0.20_wm_rvg file is not created by the Watchman. The name of the replication link
that is created by the Watchman should be a_to_b_rlk or b_to_a_rlk.
2. Check the name of the replication link in VEA. The name is displayed as
rlk_10.0.0.20_wm_rvg. The problem is caused by inconsistency of the name of the replication
link. After contacting the onsite engineer, it is confirmed that the replication link is established
through VEA.
3. Set the name of the replication link in VEA to a_to_b_rlk or b_to_a_rlk.
4. Stop the application and run the following command to delete the replication link:
#sh /etc/wmscript/stoprep
5. Setting up the replication link through the Force Active or Force Standby operation on the
Watchman client is successful.
Suggestions and
In the Watchman HA system, use the Watchman to manage and perform operations, rather than
Summary:
through VEA.
6.13 Operating the N2000 BMS Through the Monitor Fails Because of a Fault of the Input
and Output Modes
Title: Operating the N2000 BMS Through the Monitor Fails Because of a Fault of the Input and
Output Modes
ID: SE0000390493
Update Time: 2009-05-14 16:15:50
Author: g92532
Product Family: Access Network Management System
Fault Type: Network Management Platform
Keywords: monitor, input, output
Permission 04Common Users Permission
Level:
92
Confidential Information of Huawei. No Spreading without Permission
Chapter 6 iManager N2000 BMS Cases
Product: iManager N2000 BMS
Product: iManager N2000 BMS