Voice Noise Caused By Pvmb Ethernet Port Working Mode In Half Duplex - Huawei MA5600 Manual

MSAN UA5000 Cases
Keywords: Maximum leak rate
Permission 01Huawei Engineers Permission
Level:
Phenomenon De
In an office, after multiple UA5000s are upgraded to a new version, the busy tone upon off-hook
scription:
occurs when the traffic is heavy. After off-hook for multiple times, the call can be successfully
made and the callee is normal. (Target version: V100R013C05B051)
Alarm Informati
Null
on:
Cause Analysi
1. The configuration of the device is incorrect.
s:
2. The hardware such as control board or cable is faulty.
3. The overload control parameters of the UA5000 are improper.
Handling Proce
1. Check the attributes of the MG interface. It is found that the attributes are proper. The MG
ss:
interface can register successfully and the system does not have abnormal alarm information.
2. Run the display runstat callInfo command to query the current call information in the system.
It is found the off-hook quantity is 50 and the communication quantity is 5. The put-through rate
is very low.
3. Check and replace the control board and its subboard (H601PVMC0+H602ETCN). The
problem persists.
4. Run the display mgc-overload-control command to check the maximum leak rate. It is found
that the value generated by the upgrade tool is 0.40. Change it to 40. The problem persists.
5. Run the DBWIN command to check the maximum leak rate that takes effect in the system
(case attachment: How to Check the Valid Leak Rate of the UA5000). It is found that the
parameter does not take effect. Reset the H248 interface and test the service again. It is found
that the service is normal.
Suggestions and
Maximum leak rate is used to restrict the number of calls initiated per second. In the subsequent
Summary:
UA5000 R13C05 and R17 versions, this overload control parameter is added. This parameter
may be abnormal if the upgrade tool is faulty.
In the future, the upgrade tool will be updated to thoroughly solve this problem. Currently,
manually change this overload control parameter after using the upgrade tool.
5.8

Voice Noise caused by PVMB ethernet port working mode in half duplex

Title: Voice Noise caused by PVMB ethernet port working mode in half duplex
ID: SE0000393188
Update Time: 2009-06-24 14:13:05
Views: 5
Author: Jendoubi Mohamed Moez
Product Family: Integrated Access
Fault Type: Narrow-band Voice Service
Keywords: PVMB half duplex
Permission 04Common Users Permission
Level:
Phenomenon Des
Subscriber connected to UA5000 PVMBV100R011.
cription:
Voice has a lot of noice and frequent disconnection.
PVMB is connected to IPMB throug eth interface and then connected to IP backbone
Alarm Informati
Loop delay=6ms
on:
Packet loss rate= 81%
Cause Analysi
The voice noice is due to packet loss rate which is very hight.
s:
The hight packet loss rate is due to ip interface.
Confidential Information of Huawei. No Spreading without Permission
Chapter 5 UA5000 Narrow-band Service
Product: UA5000
79