Cpe Under Ma5600T Forward Padis From Other Cpe Cause Pppoe User Disconnected Randomly - Huawei MA5600 Manual

MSAN UA5000 Cases
In this case, the multicast mode of the MA5600T is IGMP proxy.
3. Because the IGMP version of the MA5600T is IGMP V2, the IGMP V3 general query
packets cannot be identified. Try to rectify this fault by modifying the IGMP version to
IGMP V3. It is found that the fault persists.
4. Through analysis, it is found that this fault can be temporarily prevented by actively
sending general query packets from the MA5600T. Run the following two command:
igmp unsolicited-report interval 30
igmp program add ip 239.255.1.2 bandwidth 15000 unsolicited enable index 1
After these two command are executed, the MA5600 sends the IGMP report packet to
the upper-layer device in each 30 seconds. Thus, this fault can be prevented
temporarily.
Suggestions and
Capturing packets on the upstream port and then analyzing them is a basic method of
Summary:
locating a fault. If we also understand protocols very well, we can locate faults quickly.
2.4 CPE under MA5600T forward PADIs from other CPE cause PPPoE user disconnected
randomly.
CPE under MA5600T forward PADIs from other CPE cause PPPoE user
Title:
disconnected randomly.
ID: SE0000308371
Information
Troubleshooting Cases
Type :
Update Time: 2007-12-26 13:45:41
Views: 12
Author: Chandler Young
Product Family: Broadband Access
Confidential Information of Huawei. No Spreading without Permission
Chapter 2 MA5600T (IP DSLAM) Cases
Quality Level:
B
Product: MA5600T MSAN
27