Panasonic LP-V Series Operation And Maintenance Manual page 306

ERROR
CODE
E640 Invalid function for combining with flying object.
E650 Invalid setting of processing element.
E651 Too short line segment of processing element.
E660 Cannot convert dxf file.
E690 Cannot finish measurement during specified time.
E700 Unable to lase as laser pumping is turned OFF.
E701 Started laser power check in laser pumping OFF
*1 state.
---------------------------
E800 (no message : Invalid input of marking trigger while
Ready is OFF.)
E811 Occurred laser stop from external terminal.
Existed invalid function character for simultaneous
use.
The following combination of the functions are not
E900 available in one file.
• Serial data marking function and rank function
• Serial data marking function and external offset
function
E901 Existed invalid character for converting into 2D code.
E902 Cannot create 2D code.
*1 : Error that may occur for LP-V / LP-W series only.
306
Error details
ME-LP400V-OP-6
Measures
• With the marking to flying object, do not use the
following functions.
• Step & repeat
• Reset at date update function
• Arbitrary point radiation
• Overwrite function
• With the equidistant marking to flying object, do
not use the following functions.
• Rank
• External offset
• Serial data marking
• Release flying object marking function with trigger
setting.
Set the distance between start and end points of the
arc smaller than double of radius.
Set the larger value to the length of the line than
width of the line.
• Save the DXF file with DXF-R12J, R13J or R14
format.
• Delete the entities which are not supported by
laser marker in the DXF file.
• Read the DXF file again to the laser marker.
• Reduce marking contents and measure marking
time.
• Speed up scan speed.
Turn ON the laser pumping and after the laser
pumping has completed, start marking.
Turn ON the laser pumping and after the laser
pumping has completed, start power check.
• Change marking timing so that trigger input is
performed after marking ready output is turned on.
• Check wiring and control procedure for I/O
terminal, wiring to communication port, and the
procedure of the communication command.
• Check the wiring of the laser stop input terminal
and contact of the switch.
• Confirm operation logic of connection device.
Delete any one of these functions from the file.
Set the character that can be converted into 2D code.
Use the condition where 2D code can be created.