Figure C.11 Shrinking The Heat Shrink Tube_Connection Between Connectors (2) - Samsung RRH-2WB Installation Manual

ANNEX C. Connector Assembly

Figure C.11 Shrinking the Heat Shrink Tube_Connection between Connectors (2)

C-12
Heat Shrink Tube
Heating Gun
4) Set the heating gun to 250 to 300°C. (482~572°F)
5) Holding one end of the heat shrink tube with your
hand, apply heat starting from the marked part at
the center using the heating gun.
6) Rotate the heating gun so that heat is evenly
distributed to prevent that bubbles are generated
or heat is concentrated to a specific part.
© SAMSUNG Electronics Co., Ltd.