Table of Contents
Advertisement
ANNEX B. Installing Feeder Cable
Table B.2 Curvature Radius of Feeder Cable for Indoor (Based on LS Feeder Line)
LS Feeder
Line
RFS Feeder
Line
Table B.3 Curvature Radius of LMR-400 (Based on Times Microwave System)
Radius of Curvature of Feeder Line
When installing a feeder line, the radius of curvature of the sections where cables
bent should be larger than the allowed radius of curvature. If the radius of
curvature for the feeder line installation is less than the allowed radius of
curvature, it may affect the performance of the system.
B-2
Specification
HFSC 6D
1/4 in.
HFSC 10D
3/8 in.
HFSC 12D
1/2 in.
HFSC 22D
7/8 in.
SCF14-50
1/4 in.
SCF38-50
3/8 in.
SCF12-50
1/2 in.
UCF78-50
7/8 in.
Specification
LMR-400
Allowed Radius of Curvature
25 mm (0.98 in.)
25 mm (0.98 in.)
32 mm (1.26 in.)
125 mm (4.92 in.)
25 mm (0.98 in.)
25 mm (0.98 in.)
32 mm (1.26 in.)
125 mm (4.92 in.)
Allowed Radius of Curvature
25.4 mm (1 in.)
101.6 mm (4 in.)
© SAMSUNG Electronics Co., Ltd.
Remark
Indoor
Remark
Installation
Repeated
Advertisement
Table of Contents
