When Connecting A Connector To Another Connector - Samsung RRH-2WB Installation Manual

C.4.2 When Connecting a Connector to another Connector
Below is the procedure for shrinking the heat shrink tube.
Figure C.10 Shrinking the Heat Shrink Tube_Connection between Connectors (1)
© SAMSUNG Electronics Co., Ltd.
Connector
1/2 in. Feeder Line
Mobile WiMAX/TD-LTE RRH-2WB Installation Manual/Ver.2.0
1) Prepare a 1/2 in. feeder line, 7/8 in. feeder line,
heat shrink tube, and heating gun to finish the
cable using a heat shrink tube.
Heat Shrink Tube (Jelly Type)
38/12 × 300 mm (11.81 in.)
7/8 in. Feeder Line
2) Inset the heat shrink tube to one end of the feeder
line and connect the connector.
Heating Gun
3) Insert the heat shrink tube, placing connector part
(where 1/2 in. and 7/8 in. feeder line will be connected)
in the center, and mark the center part.
C-11