Table of Contents
Advertisement
ANNEX C. Connector Assembly
5) Insert the o-ring, clamping nut, insert ring and N type-male body to the stripped 1/2 in. feeder line in
this order. O-ring is inserted into the second groove from inside of outer insulator.
6) Tighten the clamping nut and N type-male body inserted into the 1/2 in. feeder line firmly using a spanner.
The recommended torque for tightening the clamping nut and N type-male body is 30~50 N.m (306~510
lbf·ft). (Note that it should only be tightened by rotating the external body with the clamping nut in a fixed
and stable position.)
Keep the
fixed state
Figure C.3 Assembling the N type-male (1/2 in. Feeder Line) Connector (3)
C-4
O-Ring
Clamping Nut
Insert Ring
N type-Male Body
© SAMSUNG Electronics Co., Ltd.
Advertisement
Table of Contents
