Parameter Window - Emergency - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Commissioning
3.2.2.1

Parameter window - Emergency

In this parameter window, the emergency response of the DALI output is parameterized.
The emergency response of the emergency lighting converter can be set in
Cx...Cy
Enable communication object
"Emergency test status" 2 byte
Options:
no: The status of the emergency test is not actively sent on the KNX.
yes: The additional communication object Emergency test status (no. 32) is enabled. The example he-
re is of a 2 byte communication object. The low byte contains the address of an emergency lighting
converter. The high byte indicates whether an emergency lighting test is in operation for this emer-
gency lighting converter and which emergency lighting converter is involved. A further parameter ap-
pears:
Converter, page 92, under the corresponding emergency lighting converter.
yes
no
send object value
Options: after a change
after request
after a change or request
after a change: The status is sent after a change.
after request: The status is sent after a request.
after a change or request: The status is sent after a change or a request.
Parameter window
DGN/S 1.16.1 | 2CDC 507 114 D0201 39