Technical Data - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Device Technology
2.1

Technical data

Supply
DALI outputs (channels):
Connections
Operating and display elements
Enclosure
Safety class
Isolation category
KNX safety extra low voltage
DALI voltage
12 2CDC 507 114 D0201 | DGN/S 1.16.1
gateway operating voltage
power consumption total via mains
current consumption total via mains
leakage loss total for device
current consumption KNX
power consumption via KNX
number of outputs
number of DALI devices
distance between DGN/S and last DALI device
2
cable cross-section 0.5 mm
2
0.75 mm
2
1.0 mm
2
1.5 mm
KNX
DALI outputs and
mains voltage
tightening torque
button
button/LED
LED , green
LED , yellow
IP 20
II
overvoltage category
pollution degree
SELV 24 V DC
typical 16 V DC (9.5...22.5 V DC)
no-load voltage
lowest supply current at 11.5 V
highest supply current
85...265 V AC, 50/60 Hz
110...240 V DC
maximum 8 W at 230 V AC and max. load
maximum 35 mA at 230 V AC and max. load
maximum 3 W at 230 V AC and max. load
maximum 10 mA
maximum 210 mW
1 x 64 DALI device (16 lighting groups)
maximum 64 to EN 62 386; DALI devices for
self-contained emergency lighting to EN 62 386-
2)
202 are supported.
1)
100 m
1)
150 m
1)
200 m
1)
300 m
KNX connection terminal,
0.8 mm Ø, single core
screw terminal
2
0.2...2.5 mm stranded
2
0.2...4 mm single core
maximum 0.6 Nm
DALI output test
for assignment of the physical address
display for operation readiness
for displaying DALI fault, constant light
for displaying test mode, slow flashing
for displaying initialisation or more than 64 DALI
devices, quick flashing
to EN 60529
to EN 61140
III to EN 60 664-1
2 to EN 60664-1
to EN 60929 and EN 62386
16 V DC
160 mA
230 mA