Communication Objects Dali Output - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Commissioning
No.
5
This communication object is enabled if in the
set with the option yes.
Sending of status values on the KNX can be triggered via this communication object. A prerequisite is that for the correspond-
ing communication objects the option after a change and/or request are parameterized with only on request.
Telegram value:
3.3.3

Communication objects DALI output

Depending on the parameterization, the communications objects change, e.g. for DALI output:
No. 10 and 11 separate communication objects or common communication object no. 10, no. 13 and 14
separate communication objects or common communication object no. 14.
Note
In the following, the communication objects are described, which relate to the overall DALI output and thus to the
DALI devices connected to it.
There are central functions (Broadcast mode) that relate to all devices of the output or coded telegrams that can be
used to control individual groups or DALI devices.
No.
10
Using this communication object, all DALI devices connected to the DALI output are switched on or off with the predefined
brightness values in the
Telegram value:
When an ON telegram is received, the parameter settings define if a predefined brightness value or the value before switch off
are set. If DALI devices are switched on independently of their brightness value and the DGN/S receives an ON telegram, all
DALI devices are set with the parameterized switch on value.
You can parameterise whether a DGN/S dims down to or jumps to the brightness values. If the switch on values are above or
below the max. or min. dimming values (dimming thresholds), the respective dimming threshold is set.
Note
For the maximum and minimum dimming values, the individual values of the lighting group remain valid.
The activated function Burn-in can influence the brightness of the DALI devices.
If an additional function Staircase lighting or Sequence is activated, this function is triggered with an ON
telegram (value 1) and the respective timing is started.
102 2CDC 507 114 D0201 | DGN/S 1.16.1
Function
Request status values
Parameter window
0 = no sending of the status values, no function
1 = all status messages are sent, provided they are programmed with the option after a request
Function
Switch
Parameter window Central
0 = OFF: all lamps switched off
1 = ON: all lamps switched on
Communication object name
General
General, page 27, the parameter Request status values is
Communication object name
DALI output
on page 32.
Data type Flags
1 bit C, W
DPT 1.017
Data type Flags
1 bit C, W
DPT 1.001