Lithium Battery Installation; Figure 2-12 6270 Oeu Enclosure - ABB XSeries G4 6200 User Manual

2.2.8.1
1) Insert the battery pack into the battery compartment (see Figure 2–12) with
2) Connect the battery pack connector to the battery connector mate that is
3) If the G4 EX unit is already wired to the 6270 enclosure, the LCD screen

2.2.9 Lithium battery installation

The following are steps for installing and verifying the connection on the lithium
battery. The lithium battery is disabled when shipped from the factory. The user
will need to connect the battery before continuing.
2.2.9.1
1) To connect the battery, remove the front cover of the G4 EX. Look for the
2) On the G4 EX board, the lithium (+) red is on top (pin 1) and the (-) black
2104349 rev. AD
Figure 2–12 6270 OEU enclosure
Step-by-step instructions
the long dimension of the battery facing outward.
wired to the charger regulator.
should display a warm start.
Step-by-step instructions
battery connector behind and to the lower right side of the display (see
Figure 2–13).
(pin 4) is on the bottom. It should be noted that this is a confined space. As
such, place the ground lead of a voltmeter on bare metal, such as the plate
behind the display, and place the positive lead on the bottom solder pad. Do
not place lead against ground.
Page 2–13