Type C; Figure 2-2 Type B Installation Configuration - ABB XSeries G4 6200 User Manual

5) Attach the pole mount bracket to the top of the 2" pipe with the U-bolts. Use
6) Remove the lower two hex screws, hex nuts, flat washers and spring lock
7) With the associated hardware removed, align the transducer's bottom
8) Upon alignment, replace the hex screws, hex nuts, flat washers and spring

2.2.3 Type C

2.2.3.1
-
2.2.3.2
-
-
Page 2–4
the provided hex nuts, flat washers and spring lock washers to tighten the
pole mount bracket to the 2" pipe.
Position the mounting bracket high enough on the pipe to
allow slope from the externally mounted manifold to the tap
valves.
washers from the transducer's attached mounting brackets.
mounting holes with those on the pole mount bracket.
lock washers through their respective mounting holes on the mounting
brackets and into the pole mount bracket. Upon completion, tighten (see
Figure 2–2).
Figure 2–2 Type B Installation Configuration
It should be noted that if this is the type of installation
configuration that the user has received from the factory,
there may be additional parts within the provided mounting
kit assembly that are not used.
Materials supplied
G4 EX mounting kit assembly and associated hardware
Materials not supplied
One 2" x 40" pipe
Standard 3 or 5 valve manifold
2104349 rev. AD