Figure 4-7 G4 Ex Board Secondary Component Side - ABB XSeries G4 6200 User Manual

13) Take the replacement G4 EX board and attach the sensor cable and the
14) Take the lithium battery cable and attach the cable to its corresponding
15) Align the mounting holes on the G4 EX board with the standoffs,. Once
16) Once in place, line up the LCD board mounting holes to the G4 EX board.
17) Take a small slot head screwdriver and attach the LCD board to the G4 EX
Page 4–12
Secondary Component Side
Figure 4–7 G4 EX board Secondary Component Side.
If the user has the 2104353–503 motherboard, they will need
to remove the processor card from
motherboard and place it into the new one. This is
accomplished by pulling back the attachment brackets and
gently unsnapping the processor card from its housing.
Once completed, take the processor card and snap it into
the replacement motherboard. Continue to step 13.
ribbon cable to their corresponding connectors.
Please note that both the sensor cable and ribbon cable pin
1 wire are red. The red edge (pin 1) of the cable should plug
into the outer most edge of the connector (pin 1).
connector (J5).
aligned, snap the board into place within the device.
Gently connect the LCD board into the G4 EX board via the J2 connector.
board using the four mounting screws.
2 50
1 49
J1
SENSOR
13 1
14 2
J6
Sensor Connector
the removed
2104349 rev. AD