Application Licensing Credit Key; Credit Key Driver Installation; Access/View The Credit Key With Pccu32 7.0 (Or Later) - ABB XSeries G4 6200 User Manual

-
3.5

Application licensing Credit Key

3.5.1 Credit Key driver installation

3.5.1.1
1) Plug the USB credit key into an available USB port.
2) The Windows operating system will recognize the credit key as new
3) Click the Next button.
4) It may be necessary to point the wizard to the PCCU32 directory in the Files
5) Upon location, click the OK button.
6) The software driver installation will begin. When it is completed, click the

3.5.2 Access/view the Credit Key with PCCU32 7.0 (or later)

To access and view the credit key, the user must use PCCU32 7.0 (or later). The
credit key is a secure device and only accessible through PCCU32.
3.5.2.1
1) Install the credit key in an available USB port.
2) Open PCCU32, but do not connect to the unit.
3) Go to the Credit Key License Utility (Operate > File Utilities > Credit Key
4) When the Credit Key License Utility screen displays, click Load to view
2104349 rev. AD
For collecting analyzer stream data, the user must have Read access to the
Analyzer Stream application and the Analyzer Operation application.
Step-by-step instructions
hardware and attempt to install the appropriate driver with the Found New
Hardware Wizard.
Needed screen. Select Browse, and locate the driver (usbkey.sys) in the
PCCU32 directory.
Finish button.
If the user inserts the credit key in a different USB port on
the computer, it will need to be installed for that new USB
port. In other words, the credit key must be installed on each
available port, if the user does not intend to use the same
USB port each time they use the credit key.
Step-by-step instructions
License Utility).
To move to the Credit Key License Utility, the user cannot
be connected to the G4 EX. The user must have PCCU32
running and the initial Totalflow PCCU32 screen displayed.
available credits on the USB key (see Figure 3–27).
Page 3–25