Mitsubishi Electric MR-D30 Instruction Manual page 49

2. INSTALLATION
(d) Attachment of the side cover
a)
1)
1)
Side cover setting clip
2)
Clip
(3) MR-J4-11K_-RJ to MR-J4-22K_-RJ, and drive units of 30 kW or more
CAUTION
The mounting screw hole on these servo amplifiers are covered and not shown at shipping. When
attaching the unit for the first time, cut off the part a) from the case after removing the side cover.
When cutting off the part a), be careful not to damage the case of the servo amplifier. After the part a) is
cut off, inside of the servo amplifier will be exposed even after the side cover or the unit is attached.
Prevent foreign materials from entering through the opened area into the servo amplifier.
For attaching and detaching the unit, refer to (2) in this section. Attachment and detachment of the cover
is in the same manner as the unit.
1) Insert the side cover setting clips into the recesses a) of the servo amplifier.
2) Push the side cover at the supporting point a) in procedure 1) until the clips clip
into place.
Avoid touching burr remained after the part a) being cut off from the case shown
in the figure below. Otherwise, it may cause injury.
2 - 8
a)