Mitsubishi Electric MR-D30 Instruction Manual page 48

2. INSTALLATION
(2) MR-J4-500_-RJ to MR-J4-700_-RJ/MR-J4-350_4-RJ to MR-J4-700_4-RJ
(a) Detachment of the side cover
a)
1)
b)
(b) Attachment of MR-D30
Guide hole
1)
1)
Guide pin
2)
Clip
(c) Detachment of MR-D30
c)
a)
2)
d)
b)
1) While pushing the clips ( a) , b)), and pull out the side cover to the arrow
direction.
1) Insert the guide pins of the MR-D30 in the guide holes located on the side of
the servo amplifier.
2) To connect the CN7 and CN9 connectors straight, push the four corners of the
MR-D30 against the servo amplifier simultaneously, and keep pushing until the
clips click into place.
3) Tighten the unit with the enclosed mounting screw (M4).
3)
1) Remove the mounting screw.
2) While pushing the clips ( a), b), c), d)), pull out MR-D30 to the arrow direction.
Do not pull the MR-D30 without removing the mounting screw.
1)
2 - 7