Installing The Ifs06 On The Concrete Floor - Huawei DBS3900 Installation Manual

DBS3900 (ICR)
Installation Guide

8.1 Installing the IFS06 on the Concrete Floor

This section describes the procedure for installing the IFS06 on the concrete floor.
Procedure
Step 1 Place the marking-off template on the floor. Then use a marker to mark four anchor points, as
shown in
Figure 8-1 Marking anchor points
(1) Wall
Step 2 Drill holes at the anchor points and install expansion bolt assemblies in the holes, as shown in
the following figure.
Take proper safety measures to protect your eyes and respiratory tract against the dust before
drilling holes.
Issue 12 (2015-04-30)
Figure 8-1.
CAUTION
NOTE
Generally, the concrete floor is solid and smooth. Therefore, you can use the center punch to help locate
the drill bit. If the conditions of the floor allow direct drilling, skip this step.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
(2) Front
8 Installing the IFS06
(3) Left
62