Installing Pgnd Cables For Rrus - Huawei DBS3900 Installation Manual

DBS3900 (ICR)
Installation Guide

15.5 Installing PGND Cables for RRUs

This section describes the procedure for installing PGND cables for RRUs.
Context
The cross-sectional area of the PGND cable for an RRU is 16 mm
Procedure
l
Issue 12 (2015-04-30)
To install the PGND cable for a DC RRU, perform the following operations:
1. Cut the cable to a length suitable for the actual cable route.
2. Add an OT terminal to each end of the cable according to the instructions in
Assembling the OT Terminal and the Power Cable.
3. Connect one end of the PGND cable to the RRU, as shown in
NOTE
Crimp OT terminals in correct directions, as shown in
Figure 15-14 Correct direction of an OT terminal
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15 Installing Cables
2 2
(0.025 in. ).
Figure 15-15.
Figure 15-14.
121