Basic Settings - ABB PST30 Installation And Commissioning Manual

Chapter 7
Settings and configuration
Top level
Settings
Figure 24: Basic Settings menu
90

7:2.3 Basic Settings

The Basic settings menu consists of the most common start/
Application
stop parameters required for the set-up. Each parameter can
Settings
be adjusted separately. For a deep description of each
Basic
parameter, see Chapter 10 "Functions" .
Settings
Enter the Basic settings
Functional
Settings
Enter the menu by selecting Basic Settings.
Presentation
Settings
Setting I
Service
Set the current that the softstarter will be exposed to i.e.
Settings
rated motor current, if the unit is connected In Line.
All
Settings
Changed
Settings
For units connected Inside Delta the Setting I
according to the current in the delta circuit = 58% (
Reset all
Settings
of the rated motor current.
Operation
Press Store to save the data after setting the current.
Mode
External By-Pass contactor (Ext ByPass)
Set the parameter to Yes if an external by-pass contactor is
used, or else No. This parameter is not available on
PSTB370...1050 since these have an integrated by-pass
contactor.
Press Store to save the data.
Start mode
Select the type of ramp that will be used during start. The
possible options are:
Press Store to save the data after setting the start ramp type.
Stop mode
Select the type of ramp that will be used during stop. The
possible options are:
Press Store to save the data after setting the stop ramp type.
e
• Volt
• Torque
• Volt
• Torque
must be set
e
)
⁄ ( )
1 3
1SFC132003M0201