Fieldbus - ABB PST30 Installation And Commissioning Manual

Chapter 7
Settings and configuration
Settings
Functional Settings
Figure 34: Fieldbus group
110

7:2.4.9 Fieldbus

To set parameters related to the fieldbus communication,
enter the Fieldbus group.
Start/Stop
Torque control
Fieldbus control (Fieldb Ctrl)
Protections
Activate the fieldbus control of the softstarter by changing to
Yes.
Warnings
Press Store to save the selected function.
Faults Fieldbus type (Fieldb Type)
Select what fieldbus type is used.
Inputs
AS-Interface
Outputs
Other
Analog Output
Press Store to save/activate the selected function.
Fieldbus
Fieldbus address (Fieldb Addr)
Seq Start
Set a unique address number between 0 and 1000 for
fieldbus communication.
Press Store to save the selected function.
Fieldbus auto disable (FB Auto Dis)
Select whether fieldbus auto disable should be activated or
not.
Press Store to save the selected function.
Caution!
The motor may start unexpectedly if there is a start signal
present when doing any of the actions listed below.
• Switching from one type of control to another (fieldbus
• Re-programming of the programmable inputs
• Reset all Settings (programmable input set to Enable)
Used for AS-Interface protocol.
Used for other protocols than
AS-Interface.
control / hardwire control). Remember that when Field-
bus auto disable is active, this switch can be done auto-
matically.
1SFC132003M0201