Application Setting - ABB PST30 Installation And Commissioning Manual

Top level
Settings
Figure 12: Application Setting menu
Application Setting
Select Back
Figure 13: Application Setting menu
Centrifugal Pump
Store Set Back
Figure 14: Application type
Centrifugal Pump
Next Back
Figure 15: Confirming Application type
1SFC132003M0201

7:2.2 Application Setting

Application
The Application setting menu consists of predefined
Setting
parameters for the selected application and should be used if
an easy and quick set-up is required. Only a few parameters
Basic
Settings
have to be set before start of the motor is possible. All
necessary input data will show up in an automatic loop.
Functional
Settings
Presentation
Settings
Service
Settings
All
Settings
Changed
Settings
Reset all
Settings
Operation
Mode
After selecting an application and performing the desired
tuning, the application should not be selected again. If this is
done, all the tuning will be reset to the default settings for the
selected application.
Enter the Application setting
Enter the menu by selecting Application Setting.
Select what type of application the softstarter is used for by
pressing Store Set. If the used application is not listed, select
the one closest and choose Tune Set (see below). Possible
applications are:
Confirm the selected application by pressing Next. If wrong
application type was selected, press Back and select the
correct type.
• Centrifugal Pump
• Hydraulic Pump
• Centrifugal Fan
• Axial Fan
• Compressor
• Conveyor
• Crusher
• Mixer
• Bow Thruster
Chapter 7
Settings and configuration
87